It might not seem like something as basic as turning off a water heater would be difficult. Many homeowners find themselves scratching their heads when trying to figure out what valves to turn! And because it varies based on whether your system is gas or electric, it can take a few extra steps to make sure everything is shut down completely. Here are easy instructions to turn off both gas and electric water heaters to make sure you do it properly.
The only time you need to turn off your water heater is when you have a leak. This can happen for many reasons from age and rust to a malfunction with the valve. As soon as you realize your water heater is leaking, you should turn off the water supply until someone can come and have a look to determine what is causing the leak. They will make repairs or suggest a replacement if the tank can’t be repaired. Some people think they need to turn off their water heater before they go away, but it is not necessary.
First, when you turn your water heater off completely you will return home to find you have no hot water. Second, you can also add wear and tear to your water heater from the effort required to shut down, turn back on and then heat an entire tank of water. It makes more sense to either lower the temperature to about 50 degrees F or to set your water heater to VAC for “Vacation Mode”. Most new models provide this handy setting.
If you aren’t sure where your water heater is located, they are usually in the basement, a utility closet, or sometimes in the garage or attic.
For gas water heaters, you’ll need to look for the temperature dial which is usually at the front on the bottom. Turn the dial off.
The plumbing line is either at the top or bottom of your water heater. Once you turn the valve off, you have successfully cut off the water supply.
If your intent is to drain the heater, you’ll need a hose hook up to the boiler drain. You can then put the hose outside to let the water drain into your yard, or you can use a bucket. However, a bucket might not be big enough depending on how much water is in your tank.
The valve tends to be on the right side of the water heater. To shut off the gas you either have a lever or a knob. If it is a lever turn it perpendicular. For knobs turn it clockwise.
The final step is to look for the relief valve near the top of the heater. Once you turn it off it allows air to enter the tank.
Your electric heater will be located in the same areas as gas water heaters.
For electric water heaters, you’ll need to find your breaker box. In most cases, the box is located either in the garage or on the exterior of your house. From there you need to find the breaker line providing power to your water heater and turn it off.
The plumbing line is either at the top or bottom of your electric water heater. Once you turn the valve off you cut off the water supply.
As with gas water heaters, if you need to drain the heater, you can attach a garden hose to the boiler drain. Either put the hose outside to let the water drain into your yard or use a bucket. However, watch the water level on the bucket to as it might not be big enough depending on how much water is in your tank.
The final step is to look for the relief valve near the top of the electric water heater. Turn it off to allow air to enter the tank.
If you are having issues with your water heater or can’t figure out how to turn it off, speak to your Denver plumber expert at Bell Plumbing and Heating today.
We’re ready to answer your questions or schedule your appointment, call now or book online!